Assemble - Numbers In Filename
Posted: Thu Aug 09, 2018 4:46 pm
Hello,
I am trying to use the "Numbers In Filename" scheme for assembly.
I wanted to leverage the Automatic settings, so I have auto set for Total and Serial, as well as YES for Match filename.
I am not using special characters, nor other numbers in the filenames.
However, none of these file pairs will assemble:
FILE_1 of 2.pdf
FILE_2 of 2.pdf
FILE 2 of 2.pdf
FILE 2 of 2.pdf
FILE 1of2.pdf
FILE 2of2.pdf
What am I doing wrong? There is 1 total reference to this assembly feature on the internet, and the manual is incomplete for this topic.
Thanks very much for helping.
I am trying to use the "Numbers In Filename" scheme for assembly.
I wanted to leverage the Automatic settings, so I have auto set for Total and Serial, as well as YES for Match filename.
I am not using special characters, nor other numbers in the filenames.
However, none of these file pairs will assemble:
FILE_1 of 2.pdf
FILE_2 of 2.pdf
FILE 2 of 2.pdf
FILE 2 of 2.pdf
FILE 1of2.pdf
FILE 2of2.pdf
What am I doing wrong? There is 1 total reference to this assembly feature on the internet, and the manual is incomplete for this topic.
Thanks very much for helping.