Checking bleed

jslater
Newbie
Posts: 6
Joined: Fri Oct 14, 2011 7:35 pm

Checking bleed

Postby jslater » Tue May 16, 2017 2:43 pm

Hello, I am setting up a workflow to QC files before they move into imposition, and one of the checks I need to perform is checking that there is enough bleed in the file. I know there's the "Select Objects Close to Page Edge" action, but it actually warns the wrong way. In other words, it throws a warning when the bleed is good instead of when it's bad. Is there a way I can set up the action list so it only warns when there is too little bleed?

enfocus
Newbie
Posts: 11
Joined: Fri May 12, 2017 9:10 am

Re: Checking bleed

Postby enfocus » Mon May 22, 2017 3:58 pm

If you wish that Enfocus checks why your Action List is not working, please contact us via the Support Portal:
https://www.enfocus.com/supportportal

jslater
Newbie
Posts: 6
Joined: Fri Oct 14, 2011 7:35 pm

Re: Checking bleed

Postby jslater » Mon May 22, 2017 8:01 pm

Thank you, but I think I got it worked out. It's worked on all my test files, and I'll see what happens when it goes live.


Return to “PitStop Pro”



Who is online

Users browsing this forum: No registered users and 1 guest