Assemble Job - Job identifier

[schmitzdp]

Hello,

I am trying to assemble several files with the ‘Assemble job’ application. I define the assembly according to an identifier that is private data. This same private data is also used to name the folder.

However, all the files pass through without being grouped.

Does this application support private data? Or have I forgotten something?

Thank you.

[magnussandstrom]

What setup do you have on the following settings?

Number of files
After N minutes
Complete condition

[schmitzdp]

What setup do you have on the following settings?

Number of files
After N minutes
Complete condition

Number of files : 0 (deactivated so ?)
After N minutes : 1
Complete condition : Nothing (deactivated so ?)

I want jobs to be grouped together by Job identifier after 1 minute.

[magnussandstrom]

I don't think you can set Number of files to 0. If you instead set Number of files to 99999999, the After N minutes have higer priority and will trigger the Assemble.

[schmitzdp]

I don't think you can set Number of files to 0. If you instead set Number of files to 99999999, the After N minutes have higer priority and will trigger the Assemble.

This resolves the job assembly issue. Thank you very much.