I have a 9 round file that is arranged
In 3 columns and 3 rows.
I want in one action command to grab 3 circles from the left column and one circle to the right,
In one command.
I tried to do that with the
Select a polygon area
And use the command
Select an object by region
And I couldn't.
He deleted all the circles.
Attached file
action only in selection
action only in selection
- Attachments
-
- Screen Shot 2020-03-06 at 01.17.47.jpg (97.68 KiB) Viewed 6989 times
Re: action only in selection
Is it possible that it is one image?
Can you post a file itself or screenshot of the same but in wireframe mode?
Can you post a file itself or screenshot of the same but in wireframe mode?
-
- Advanced member
- Posts: 458
- Joined: Wed Apr 22, 2015 4:28 pm
Re: action only in selection
The Polygon tool is not the one to use.
we are actually going to remove that as it's legacy.
What you need are two region selections joined with an 'AND'
Like this.
we are actually going to remove that as it's legacy.
What you need are two region selections joined with an 'AND'
Like this.
Head of Product Management @ Ultimate
abc@imposition.com
abc@imposition.com
Re: action only in selection
Ok, I understand, thank you.
But what does the polygon tool do?
But what does the polygon tool do?
Re: action only in selection
Used with "And"
Both conditions must exist and so it does not work.
What to do - use "or"
Both conditions must exist and so it does not work.
What to do - use "or"
-
- Advanced member
- Posts: 458
- Joined: Wed Apr 22, 2015 4:28 pm
Re: action only in selection
Polygon is an old tool that worked with a Scitex created PDF.
Long before my time.
We were planning to remove it in the next version to avoid any confusion.
Can you send me the test file and I'll make the Action for you?
Long before my time.
We were planning to remove it in the next version to avoid any confusion.
Can you send me the test file and I'll make the Action for you?
Head of Product Management @ Ultimate
abc@imposition.com
abc@imposition.com
Re: action only in selection
Hi abailescollins
at the end I settled.
You help me understand the logic of the software - and, if,
And with your help I succeed.
Maybe you should make a tool that chooses a polygonal choice? This is very useful in my opinion.
at the end I settled.
You help me understand the logic of the software - and, if,
And with your help I succeed.
Maybe you should make a tool that chooses a polygonal choice? This is very useful in my opinion.