I need to compare the trim box in a pdf to the trim defined in the xml job ticket.
Posted: Fri Feb 24, 2017 4:15 am
I need to compare the trim box in a pdf to the trim defined in the xml job ticket.
1) Which part of Switch do I use to pull the info from the PDF? (I have Pitstop Server if required but would still need to know how if that's the way)
2) Which part of Switch do I use to pull the info from the ticket?
3) How do I perform the comparison?
4) Can I allow for orientation mismatches? e.g. 210x297 is good for 297x210
This is to form a drag and drop flow where the sales rep can drop in a job and be informed pass/fail. It's stand alone, not part of a larger flow.
1) Which part of Switch do I use to pull the info from the PDF? (I have Pitstop Server if required but would still need to know how if that's the way)
2) Which part of Switch do I use to pull the info from the ticket?
3) How do I perform the comparison?
4) Can I allow for orientation mismatches? e.g. 210x297 is good for 297x210
This is to form a drag and drop flow where the sales rep can drop in a job and be informed pass/fail. It's stand alone, not part of a larger flow.