Length of a cut path as a variable

[Danp]

Hi there,

Is it possible to save the length of a measured cut path as a variable and then use this as part of the file name?

Thanks in advance for any help.

Dan

[JimmyHartington]

If you have Switch it is possible.

Have an action list which check if length of cut path is less than 0.
The XML-report will then have the measured length.
This can be used as a variable in Switch to rename the file.

Royal TSX-Flow-server03-2025-09-19 at 15.36.12@2x.jpg (217.61 KiB) Viewed 1223 times

[Danp]

Thanks very much Jimmy, will give that a go.

Best regards,

Dan